Edgebandings for raised floor systems

The edgebandings intended for the sector of raised floors can be produced in two different types according to the needs of customers:

Both types of products are done with a surface finish that reset the crunch due to friction between the tiles.
On the back of the board is coated a primer that is reactivated once placed in contact with hot melt adhesives used by customers during the floors production. The products thus obtained are suitable to be glued on each type of panel whether chipboard or calcium sulfate.
The edgebandings can be done in different thicknesses from a minimum of 0.45 mm to a maximum of 3 mm.
Technical and safety data sheets are available for all products with specific attention to the results obtained by test conducted by certified laboratories.
The great experience gained in over 30 years of collaboration with the best Italian manufacturers of access floors has allowed the company to deliver products that meet the sector requirements.